Programma del corso

Guida alla Facoltà di Ingegneria 2005-2006
 

 

 
A.A. 2005/2006
1st Degree Courses
ING-IND/22
Materiali Polimerici 2 (3 cfu)

Course: Mechanical Engineering

italian version

Aims :

 

The student will be directed to an analysis of design problems to planning the production of the parts. For manufacture with polymers can be made by different types of conversion in comparison each to another, students must get technical economical evaluations.

 

Topics :

 

Main conversion technologies of the plastic at high pressure: compression molding, transfer moulding, injection moulding. Close examination of the technique of injection molding with the study of manufactured articles and with the planning of the technology. Simple numerical exercises of planning the moulding cycles with times and geometrical parameters definition. Mass manufactured articles and semi-expansion parts. Extrusion dies. Extrusion of profiles and cables. Machineries, control's parameters. Point of job of the extruder. Exercises of calculation. Production of containers and of films by extrusion. Method of the conversion by cast film. Gas-assisted technologies. Technologies at low pressure. Thermoforming. Composite materials.

Textbooks :

 

Appunti del docente
W. MICHAELI, Plastics Processing, HANSER PUBLISHERS

 

Exam :

 

Test written with questions continuation from eventual oral additional test

 

Tutorial Session :

 

Tuesday and Thursday from hours 10 to the 12

 

Facoltà di Ingegneria - Via Brecce Bianche - Monte Dago - 60131 Ancona - Tel. 0039-071-2204708